|Home||» Products||» Automatic Voltage Controller||» Automatic Voltage Controller|
If you are getting high voltage more than 230 VOLTS SINGLE PHASE/400 VOLTS THREE PHASE Then you can save substantial amount of MONEY by Installing
JEMC is manufacturing Automatic Voltage Controllers (AVC) & Rectifier Equipments for Electroplating/Hydrogenation and also Special Purpose Transformers for industrial applications since 1967.
We have supplied more than 5000 Automotive voltage controller/Rectifiers above 100 KVA capacity to different type of industries/required corporate houses throughout India as well as few outside India. As per customers feedback they are working to their full satisfaction and hence getting repeat orders from them. The equipment is the need of every power consumer.
Automatic Voltage Controller is an industrial robot which first monitors items rectifiers the voltage variation round the clock & whenever there is any voltage fluctuation, it rectifiers to the desired level in few seconds.
The Basic purpose of AVC is to maintain the desired voltage and to reduce the breakdown of electrical equipments due to low/high voltage. Power saving Reduction in MDI and improvement of P.F. will be added advantages at high voltage.
Capital & Interest cost is just 1.5% per month.
Saving by reduction in breakdown of electrical equipment and energy saving shall be 4-8 times of capital & interest cost. Voltage variation is common phenomenon. The input voltage is generally low during day time and high during night hours.
Apart from above, few months in a year/few days in a month/few hours in a day the voltage is either low or high due to the following reasons:
Therefore for smooth function it is suggested to install AVC with +- 15% or 20% input voltage variation range i.e. 340-460 volts or 320-480 model.
In India all electrical equipments are designed for 230/400 volts single/three phase. After installation of Automatic Voltage Controller you will have number of the following Advantages:-
Suggestion : It is suggested to note down hourly input voltage by installing digital voltmeter at the security gate of your factory premises for a week.
Check : Failure rate of Electrical Equipments such as Bulbs, Tubes, Chokes, Contactor Coil & Electronic Equipments etc.
|Voltage Variation||% Reduction possible in breakdown of Electrical Equipments with AVC||% Power saving possible with AVC|
|Motor Below 10 HP||Lighting Load||Motor Below 10 HP||Lighting Load|
|380-400 V||No Reduction and No AVC required||No Power saving and No AVC required|
At low voltage you will not be able to operate your machines at â€š rated capacity resulting in lower production.
You need to run the machines on DG set. The power cost of DG set is three times as compared to charge by electricity board.
Jindal's Servo is available in a wide range and various models. The standard Three phase models are suitable for balanced & unbalanced supply and loads.
|Linear Regulator with rolling contact carbon roller assembly||Dimmer Regulator sliding contact carbon brush assembly|
It is such a fine equipment, which first monitors the voltage variation around the clock then rectifiers the same if required instantaneously & cost just 1.5% per month of capital & interest and will save 4-8 times as explained here under:
|Life of AVC Approx. 10 Years Cost Per Month for 10 Years (Rs. 10,00,000 / 120 months)||Rs. 8,333/-|
|Interest P.M. on Reducing Basis @ 12% on Rs. 10,00,000/-||Rs. 5,000/-|
|Total Rs. 13,333/-|
It is a equipment, which pays back its cost within 1-2 years. If we try to rectify voltage variation manually it might be rectified but cannot be monitor always.
With the expenses of Rs. 13,333/- per month, you will be able to achieve savings of more than Rs. 55,000/1,10,000/- per month depending upon the input voltage variation and working hours of the plant due to the following advantages;
The Above advantages have been confirmed by the customers by placing repeat orders for their expansion of Plants.